HDMI-3D-OPT series – User's Manual 68
Analog Audio Output Level Settings by Steps
INFO: The following settings are valid only for analog audio output port of the receiver.
Volume in dB
Command format: CALL●
n
Response format: m0●
n
Parameters:
Example:
˃ CALL /MEDIA/AUDIO/O3:stepVolumedB(-1)
˂ m0 /MEDIA/AUDIO/O3:stepVolumedB
Explanation:
Volume in Percent
Command format: CALL●
n
Response format: m0●
n
Parameters:
Example:
˃ CALL /MEDIA/AUDIO/O3:stepVolumePercent(5)
˂ m0 /MEDIA/AUDIO/O3:stepVolumePercent
Explanation:
Command format: GET●
Response format: pw●
Example:
˃ GET /MANAGEMENT/NETWORK.DhcpEnabled
˂ pw /MANAGEMENT/NETWORK.DhcpEnabled=true
Change the DHCP State
Command format: SET●
Response format: pw●
Example:
˃ SET /MANAGEMENT/NETWORK.DhcpEnabled=false
˂ pw /MANAGEMENT/NETWORK.DhcpEnabled=false
Command format: GET●
Response format: pr●
Example:
˃ GET /MANAGEMENT/NETWORK.IpAddress
˂ pr /MANAGEMENT/NETWORK.IpAddress=192.168.0.100
Command format: SET●
Response format: pw●
Example:
˃ SET /MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.85
˂ pw /MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.85
Command format: GET●
Response format: pr●
Example:
˃ GET /MANAGEMENT/NETWORK.NetworkMask
˂ pr /MANAGEMENT/NETWORK.NetworkMask=255.255.255.0
Command format: SET●
Response format: pw●
Example:
˃ SET /MANAGEMENT/NETWORK.StaticNetworkMask=255.255.255.0
˂ pw /MANAGEMENT/NETWORK.StaticNetworkMask=255.255.255.0
To Next Page
Loading...
Need help?
General
