ASSIST is not available due to a malfunction
and is deactivated. If you confirm the mes-
sage with 3, the display shows the next sub-
menu.
X
Press f or g to activate or deactivate
ATTENTION ASSIST.
X
Press 3 to confirm.
The next submenu is shown in the display.
Further information can be found under "ATTEN-
TION ASSIST" (Y page 199).
Activating/deactivating the Intelligent
Light System
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Press È to select the Settings menu.
X
Press 3 to select the Intell. Light Sys‐
tem submenu.
The display shows the current status.
If the Intell. Light System inoperative
message is shown in the display, the Intelli-
gent Light System is not available due to a
malfunction and is deactivated. If you confirm
the message with 3, the display shows the
next submenu.
X
Press f or g to activate or deactivate the
Intelligent Light System.
X
Press 3 to confirm.
The next submenu is shown in the display.
When you activate the Intelligent Light System
function, you activate the following functions:
R
Motorway mode
R
Active light function
R
Cornering light function
R
Extended range foglamps
Further information can be found under "Intelli-
gent Light System" (Y page 117).
Setting permanent SPEEDTRONIC
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Press È to select the Settings menu.
X
Press 3 to select the Winter tyres sub-
menu.
The display shows the current speed limita-
tion setting.
X
Press f or g to set permanent SPEED-
TRONIC in increments of ten. Selecting the
Off setting switches permanent SPEED-
TRONIC off.
X
Press 3 to confirm.
The next submenu is shown in the display.
Further information can be found under "Per-
manent SPEEDTRONIC" (Y page 191).
Selecting the permanent display func-
tion
United Kingdom only:
This function is not available. The display per-
manently shows the digital speed in km/h in the
header. The outside temperature is displayed
with the odometers (Y page 223).
For all countries except the United Kingdom:
With the Permanent display: function, you
can switch the display in the header between
outside temperature and speed.
If the display shows the speed in the header, the
outside temperature is shown with the odome-
ters (Y page 223).
The additional speedometer unit in the header is
always inverse to the speedometer unit.
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Using È select the Settings menu.
X
Using 3 select the Permanent display:
submenu.
The display shows the selected setting Out‐
side temp. or Addit. speedo.
X
Change the setting by pressing f or g.
X
Press 3 to confirm.
The next submenu is shown in the display.
Selecting the unit for the distance
In the Disp. unit distance: submenu, you
can select whether the display shows certain
information in kilometres or miles.
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Press È to select the Settings menu.
X
Press 3 to select the Disp. unit dis‐
tance: submenu.
The display indicates the selected setting km
or miles.
On-board computer (vehicles without steering wheel buttons)
227
On-board computer and displays
Z
To Next Page
Loading...
Need help?
General
