warning signals during the opening proce-
dure.
The indicator lamp in the Å or Æ sliding
door button in the centre console flashes for
the duration of automatic operation.
The indicator lamp in the Å or Æ sliding
door button in the centre console is lit when-
ever the respective sliding door is open.
Depending on the vehicle equipment, the dis-
play can also show the Sliding door open
message.
X
To close: briefly press the respective Å or
Æ sliding door button in the centre con-
sole.
or
X
Briefly press sliding door button A in the
door frame.
or
X
Briefly press rocker switch = forwards.
The sliding door is released from its lock and
automatic operation is started. The sliding
door closes.
If you use the Å or Æ sliding door but-
ton in the centre console you will hear two
warning signals during the opening proce-
dure.
The indicator lamp in the respective Å or
Æ sliding door button in the centre console
goes out whenever the sliding door is closed.
X
To interrupt automatic operation: press
the respective Å or Æ sliding door but-
ton in the centre console again.
or
X
Press sliding door button in the door frame
A.
or
X
Briefly pull back rocker switch =.
i
In unfavourable operating conditions, e.g.
frost, ice or heavy soiling, you can press and
hold the relevant sliding door button. The
electric sliding door moves with increased
force. Observe that, in such circumstances,
the obstacle detection is less sensitive. To
stop the movement, release the sliding door
button.
Programming the key button for the
sliding door
If the vehicle is fitted with two electric sliding
doors, the 5 sliding door button on the key
can only be programmed for one of the two slid-
ing doors. You can then open or close the selec-
ted sliding door with the 5 button on the key.
:
Sliding door button for sliding door on the
left-hand side
;
Sliding door button for sliding door on the
right-hand side
X
Make sure that the sliding door to be pro-
grammed is open.
X
Turn the key to position 2 in the ignition lock.
X
Press and hold the Å or Æ sliding door
button in the centre console for the appropri-
ate sliding door until the sliding door is closed
and four tones have sounded.
The display shows the Left-hand elec‐
tric sliding door key programmed/
Right-hand electric sliding door
key programmed or Lt slid. door pro‐
grammed/Rt slid. door programmed mes-
sage.
Resetting the sliding door
You must reset the sliding door if there has been
a malfunction or an interruption in the voltage
supply.
X
If the sliding door is open: close it by hand.
X
Using the Å or Æ sliding door button on
the centre console, open the sliding door at
least 40 cm and then close the sliding door
completely.
86
Electric sliding door
Opening and closing
To Next Page
Loading...
Need help?
General
