For example, when the brakes are fully
applied, forces act which can be many times
that of the weight force of the load. To dis-
tribute the load evenly, always use several
lashing points. Load the lashing points as
evenly as possible.
Always observe the operating instructions or the
lashing strap manufacturer's instructions for
the operation of the lashing strap.
Securing loads on the load compartment floor
by lashing them down is only recommended for
lightweight loads. Lay anti-slip mats underneath
the load to secure the load additionally.
Notes and information on:
R
the operation of the lashing eyelets and lash-
ing points can be found in the "Securing a
load" section (Y page 314)
R
the maximum loading capacity of the lashing
points can be found in the "Technical data"
section (Y page 389)
R
the maximum loading capacity of the lashing
strap can be found on the lashing strap label
If the label is missing or illegible, the lashing
strap is ready to be discarded. Such a lashing
strap must be removed from use.
If stickers have been included in the delivery:
X
Clean the surface before sticker : is affixed.
The stickers must be affixed to a flat, metallic
surface free from grease and dust.
X
Affix stickers : on every side of the vehicle in
close proximity to the loading rails in a clearly
visible location.
Tensioning strap
X
Observe the important safety notes
(Y page 316) and the notes in the "Securing a
load" section (Y page 314).
X
To tighten the tensioning strap: press ten-
sioning lever = and keep it pressed.
X
Guide tensioning strap : between tension-
ing lever = and brace ; as illustrated and
tighten it.
X
Release tensioning lever =.
X
To release the tensioning strap: press ten-
sioning lever = and pull tensioning strap :
out from the strap buckle.
Lashing straps
317
Transporting loads with the vehicle
Z
To Next Page
Loading...
Need help?
General
