Mitsubishi S6R Series User Manual

11-17
Chapter 11 INLET AND EXHAUST SYSTEMS
3. Inlet and Exhaust Systems - Install
3.1 Exhaust Pipe and Exhaust Manifold - Install
Install the parts in the reverse order of the disassemble sequence. (Refer to the illustration for disassembling.)
Thoroughly clean and dry the inlet and exhaust passages.
3.1.1 Exhaust Manifold Coupling - Tighten
(1) Apply MOLYKOTE (molybdenum disulfide anti-seize)
or equivalent to the bolt.
(2) Tighten the nuts to the specified torque.
(3) Lightly shake the outer circumference of exhaust mani-
fold coupling to make a snug contact between exhaust
manifold mating face and exhaust manifold coupling
taper face.
(4) Tighten the nuts to the specified torque.
(5) Lightly shake again to verify the snug fitting.
Exhaust Manifold Coupling - Tighten
3.1.2 V-clamp - Tighten
(1) Apply MOLYKOTE (molybdenum disulfide anti-seize)
or equivalent to the bolt.
(2) Tighten the nuts to the specified torque.
(3) Lightly tap the outer circumference of V-clamp to make
a snug contact between exhaust manifold mating face
and V-clamp tapered face.
(4) Tighten the nuts to the specified torque.
(5) Lightly shake again to verify the snug fitting.
V-clamp - Tighten
3.2 Air Cooler - Install
Install the Air cooler to the crank case, and tighten bolts to
the specified torque.
Air Cooler - Install
Do not distort the exhaust manifold coupling.
9 ± 0.45 N·m
{0.9 ± 0.04 kgf·m}
[6.6 ± lbf·ft]
Do not deform the V-clamp. This results in the
decrease of tightening force.
V groove
portion
Bolt
1/4 - 28UNF:
9 ± 0.45 N·m
{0.9 ± 0.04 kgf·m}
[6.6 ± 0.33 lbf·ft]
108 ± 10.8 N·m
{11 ± 1.1 kgf·m}
[80 ± 8.0 lbf·ft]

Mitsubishi S6R Series Specifications

General

Brand	Mitsubishi
Model	S6R Series
Category	Engine
Language	English