5-4
Chapter 5 DISASSEMBLY OF BASIC ENGINE
1.1 Fuel Inlet Connector - Remove
Remove the fuel inlet connector.
Fuel Inlet Connector - Remove
1.2 Nozzle Assembly - Remove
(1) Remove the nozzle gland.
(2) Remove the nozzle holder with nozzle remover.
(3) Remove the gasket remained inside the cylinder head.
Nozzle Assembly - Remove
1.3 Valve Clearance - Inspect
Inspect the valve clearance, and know the current condition.
For the inspection procedure, refer to "Valve Clearance -
Inspect and Adjust" of "ASSEMBLY OF BASIC ENGINE.
"
Valve Clearance - Inspect
Fuel inlet connector
When removing the nozzle assembly with nozzle
remover, be careful not to get caught your fingers
between the nozzle remover weight, bar and plate.
Before removing the nozzle assembly, clean the noz-
zle assembly to prevent foreign material from getting
into the cylinder head. Keep the nozzle and the fuel
inlet connector as a set, and handle the nozzle with
care to avoid damage to the nozzle tip.
Nozzle remover
P/N: 33591-10101
Gasket
Nozzle gland
Valve clearance
To Next Page
Loading...
Need help?
General
