Mitsubishi S6R Series User Manual

5-8
Chapter 5 DISASSEMBLY OF BASIC ENGINE
2. Rear Mechanism - Disassemble and Inspect
Understanding of the current engine condition before disassembling is very important to know the cause of trouble and do the
efficient work.
Depending on the maintenance work or purpose, it is desirable to inspect some of the following items before proceeding with
any job.
Flywheel Face and Radial Runout - Measure
Timing Gear Backlash - Measure
Idler Gear and Camshaft End Play - Measure
Rear Mechanism - Disassemble and Inspect
Note: The shape of flywheel differs in accordance with the customization and specification.
2
Wear, flaw, aging
Crack, dowel hole defect
Flaw, wear
Clogging
Flaw, wear
Clogging, wear
Peeling, wear
Crack, dowel hole defect,
flaw, abnormal wear
Flaw
Replace
Replace
Replace
5
Replace
1
9
Replace
9
Replace
Hour meter spec
Non-attachment spec
12
10
6
4
13
8
3
7
14
15
11
Electronic governor spec
Oil pressure governor spec
Electronic governor spec
Disassembling Sequence
1 Pick up (Electronic governor spec)
2 Hour meter (With hour meter spec)
3 Flywheel (Standard: approx 83 kg [183 lb])
(FCD spec: approx 42 kg [93 lb])
(Land clutch: approx 100 kg [220 lb])
4 Timing gear case (Approx 88 kg [194 lb])
5 Oil seal
6 Thrust plate
7 Idler gear
8 Accessory drive
(Refer to the chapter "FUEL SYSTEM" for disassembly,
inspection and assembly.)
9 Governor drive (Oil pressure governor spec)
(Refer to the chapter "FUEL SYSTEM" for disassembly,
inspection and assembly.)
10 Camshaft gear
11 Thrust plate
12 Camshaft gear (Approx 32 kg [71 lb])
13 Idler shaft
14 Rear plate
15 Nozzle plate

Mitsubishi S6R Series Specifications

General

Brand	Mitsubishi
Model	S6R Series
Category	Engine
Language	English