Wireless Configuration
6-53
Figure 6-23 Association Access Control List (ACL) screen
3. Select the + Add Row button to add an association ACL template that requires configuration.
4. Set the following parameters for the creation or modification of the Association ACL:
5. Select the + Add Row radio button to add MAC address ranges and allow/deny designations.
6. Select OK to update the Association ACL settings. Select Reset to revert to the last saved configuration.
6.5.1 Association ACL Deployment Considerations

Association ACL
Before defining an Association ACL configuration and applying it to a WLAN, refer to the following
deployment guidelines to ensure the configuration is optimally effective:
Association ACL If creating an new Association ACL, provide a name specific to its function.
Avoid naming it after a WLAN it may support. The name cannot exceed 32
characters.
Precedence The rules within a WLAN's ACL are applied to packets based on their
precedence values. Every rule has a unique sequential precedence value
you define. You cannot add two rules’s with the same precedence value.
The default precedence is 1, so be careful to prioritize ACLs accordingly as
they are added.
Starting MAC
Address
Provide a starting MAC address of the wireless client, for non unicast and
multicast packet transmissions.
Ending MAC
Address
Provide an ending MAC address of the wireless client, for non unicast and
multicast packet transmissions.
Allow/Deny Use the drop-down menu to either Allow or Deny access if a MAC address
matches this rule.
To Next Page
Loading...
Need help?
General
