Motorola AP-6511 User Manual

Device Configuration
5-47
18.Set or override the following Non-Unicast Traffic values for the profile’s supported Access Point radio
and its connected wireless clients:
19.Refer to the Client Load Balancing field to define or override how the Access Point radio supports
clients based on a maximum count for the radio, a count trigger and throughput.
20.Refer to the Sniffer Redirect (Packet Capture) field to define or override the radio’s captured packet
configuration.
21.Select OK to save or override the changes to the Advanced Settings screen. Select Reset to revert to
the last saved configuration.
5.4.2 Overriding a Profile’s Network Configuration
Setting a profile’s network configuration is a large task comprised of numerous administration activities.
Each of the configuration activities described can have an override applied to the original profile
configuration. Applying an override removes the device from the profile configuration that may be shared by
Non-Unicast Transmit
Rate
Use the Select drop-down menu to launch a sub screen to define the data rate
broadcast and multicast frames are transmitted. Seven different rates are
available if the not using the same rate for each BSSID, each with a separate
menu.
Non-Unicast
Forwarding
Define whether client broadcast and multicast packets should always follow
DTIM, or only follow DTIM when using Power Save Aware mode. The default
setting is Follow DTIM.
Client Count Weight Sets the client load per Access Point radio between 0 - 10. Motorola Solutions
recommends considering the client load on an Access Point before defining its
radio configuration. The higher the number of clients, the greater the strain on
a radio’s resources. The default weight is 10 clients. Setting the weight to 0
defines the weight as not considered.
Client Count Trigger
Number
The trigger value is the number of client association on the Access Point radio
before load balancing is triggered. The configurable range is between 1 - 255.
The default trigger client count is 10 clients.
Throughput Weight Set a throughput weight ratio on the Access Point radio between 0 - 10. The
higher the value, the greater the anticipated load on the Access Point radio.
The default throughput weight is 0.
Throughput Trigger
Number
When the average Access Point radio throughput exceeds the trigger number
(as defined between 1 - 1,100), load balancing is initiated for the radio. The
default throughput trigger number is 10.
Host for Redirected
Packets
If packets are re-directed from a Access Point radio, define an IP address of a
resource (additional host system) used to capture the re- directed packets. This
address is the numerical (non DNS) address of the host used to capture the re-
directed packets.
Channel to Capture
Packets
Use the drop-down menu to specify the channel used to capture re-directed
packets. The default value is channel 1.

Motorola AP-6511 Specifications

General

Brand	Motorola
Model	AP-6511
Category	Wireless Access Point
Language	English