Unblock the traffic meter after the traffic limit is reached
If you configured the traffic meter to disconnect and disable the Internet connection
after the traffic limit is reached, you cannot access the Internet until you unblock the
traffic meter.
CAUTION: If your ISP set a traffic limit, your ISP might charge you for the
overage traffic.
To unblock the traffic meter:
1.
Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2.
Enter orbilogin.com.
A login window displays.
3.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Traffic Meter.
The Traffic Meter page displays.
5.
In the Traffic Control section, clear the Disconnect and disable the Internet
connection check box.
6.
Click the Apply button.
Your settings are saved and the router restarts.
Change the NTP server
By default, the router uses the NETGEAR Network Time Protocol (NTP) server to sync
the network time. You can change the NTP server to your preferred NTP server.
To change the NTP server to your preferred NTP server:
1.
Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
User Manual123Mantain and Monitor Your
Network
Whole Home Quad-Band Mesh WiFi 7 System
To Next Page
Loading...
Need help?
General
