3.
Reset button: Use the Reset button to restart (reboot) the router or reset the router
to its factory default settings:
•
Restart the router: Press the Reset button for less than five seconds. The Power
LED lights solid amber and the router restarts.
•
Reset the router to its factory default settings: Press and hold the Reset button
until the Power LED starts blinking amber. The router resets and returns to its
factory settings. For information about the factory settings, see Factory settings
for the Orbi router on page 162.
4.
2.5G Multi-Gigabit LAN ports 1–4: You can connect a LAN device to each of the
four Multi-Gigabit RJ-45 LAN ports, each of which support speeds up to 2.5 Gbps.
5.
10G Ethernet port: This Ethernet port provides a wired connection speed of up to
10 Gigabit Ethernet (10GbE). You can connect this port to the 10 Gigabit Ethernet
(10GbE) port on the satellite to create a wired backhaul connection. For more
information, see Set up your satellite with a wired connection to your router on page
20.
6.
10G Internet port: Connect your modem to this port and get up to 10 Gigabit
Ethernet (10GbE) Internet speeds.
7.
Power LED: For more information about the Power LED behavior, see Orbi router
LED behavior on page 13.
8.
Power connector: Connect the power adapter that came with your router to this
port.
Orbi router LED behavior
The Orbi router has an LED on the front and a Power LED on the back.
The following table describes the LED behavior for the router’s Power LED.
Table 1. Power LED behavior
DescriptionLED color
Power is on.Solid green
The router is restarting.Solid amber
The router’s firmware is resetting to its factory default settings.Blinking amber
The router’s firmware is corrupted.Blinking red
Power is not supplied to the routerOff
-
User Manual13Overview and Setup
Whole Home Quad-Band Mesh WiFi 7 System
To Next Page
Loading...
Need help?
General
