Internet port and the 10G Ethernet port on your router to the Ethernet ports on the
modem.
In a WAN aggregation setup, the 10G Ethernet port on your router does not function
as a LAN port but as a secondary Internet port.
To set up WAN aggregation with the Orbi router:
1.
Set up WAN aggregation on your modem.
For information about how to set up WAN aggregation on your modem, see the
documentation that came with your modem.
2.
Log in to your router and enable WAN port aggregation:
a.
Launch a web browser from a computer or mobile device that is connected to
the Orbi network.
b.
Enter orbilogin.com.
A login window displays.
c.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
d.
Select ADVANCED > Setup > Internet Setup.
The Internet Setup page displays.
e.
In the WAN Preference section, select the WAN aggregation (10 Gbps +
10 Gbps, LACP-IEEE802.3ad) radio button.
f.
Click the Apply button.
Your settings are saved.
3.
Connect the 10G Internet port and the 10G Ethernet port on your router to two
Ethernet ports on your modem.
Change the WAN preference back to the Internet port
By default, your router’s WAN preference is set to use the 10G Internet port, and you
can connect a modem to the 10G Internet port.
If you previously set up WAN aggregation, you can change the WAN preference back
to the 10G Internet port.
After you do so, the 10G Ethernet port is available for a high-speed LAN connection.
The 10G Internet port must remain connected to the modem.
User Manual79Specify Network Settings
Whole Home Quad-Band Mesh WiFi 7 System
To Next Page
Loading...
Need help?
General
