Omron H8PS User Manual

4.2 Advance Angle Compensation (ADV) Function
4-9
HOW TO USE THE
ADVANCED FUNCTIONS
4.2.3 Operation
<Example>
Setting an ADV value for cam 4 (speed: 100 r/min, advance angle: 2°)
(The same example as explained in "4.2.1 What Is the Advance Angle Compensation (ADV) Function?")
Selecting the mode
Selecting the
programming mode
Setting a bank number
Designating the cam No./step No.
Set the mode switch to PRGM or TEST.
(The explanation below assumes that the switch
is set to TEST.)
The programming mode switch may be set as
desired.
(The explanation below assumes that the
switch is set to TCH.)
Change the cam number to "4" by pressing the
[+] or [−] key of the CAM keys.
Switching to the ADV
function setting screen
Press the [ADV] key (for less than 3 seconds) to
change the screen to the ADV function setting
screen. ("ADV" will appear on the display.)
"r/min" indication flashes in both Main display
and Sub-display, indicating that the Cam
Positioner is ready for speed setting.
Press the [+] or [−] key of the ANGLE keys (*) to
set the desired speed (100 r/min, in this
example).
Switching to the ADV function setting screen is possible
only when the designated cam number is in the range 1
to 7.
If the [ADV] key is pressed while any other cam number
is designated, the operation is disregarded.
Setting the speed
Press the [WRITE] key.
(Make sure that "100 r/min" is displayed in Sub-
display (right).)
The "°" symbol starts flashing (in both Main
display and Sub-display), indicating that the
Cam Positioner is ready for ADV value setting.
Determining the set speed
PRGM
TEST
RUN
PRGM
TEST
RUN
TCH
MAN
CAM
STEP
TST
CAM
STEP
TST
CAM
STEP
TST
CAM
STEP
TST
CAM
STEP
TST
* When setting the speed by holding down the [+] or [−]
key to change the displayed speed quickly, the displayed
speed changes more quickly if the other key is pressed.
When banks are used with 16-/32-output models
Set the bank number of the bank to be used.
For details on setting a bank function, refer to
"4.8 Bank Function (F7/F8/F9)".

Omron H8PS Specifications

General

Brand	Omron
Model	H8PS
Category	Valve Positioners
Language	English