Rigol DS2000E Series Programming Guide

2 Command System RIGOL
DS2000E Programming Guide
2-147
:MEASure:HISTory:DISPlay
Syntax
:MEASure:HISTory:DISPlay <bool>
:MEASure:HISTory:DISPlay?
Description
Enable or disable the measurement history; or query the current on/off status of the measurement
history.
Parameter
Name Type Range Default
<bool> Bool {{1|ON}|{0|OFF}} 0|OFF
Explanation
 The measurement history cannot be enabled when there is not any measured item.
 When the measurement history is enabled, the latest 10 measurement results of at most 5
measurement items turned on last can be displayed.
Return Format
The query returns 1 or 0.
:MEASure:HISTory:DMODe
Syntax
:MEASure:HISTory:DMODe <mod>
:MEASure:HISTory:DMODe?
Description
Set or query the display mode of the history measurement data.
Parameter
Name Type Range Default
<mod> Discrete {TABLe|GRAPh} GRAPh
Explanation
 TABLe: display the measurement results of the last 10 measurements of at most 5 measurement
items that are enabled last in table mode.
 GRAPh: display the measurement results of the last 10 measurements of at most 5 measurement
items that are enabled last in graph mode. The measurement points are connected using linear
interpolation.
Return Format
The query returns TABL or GRAP.

Rigol DS2000E Series Specifications

General

Bandwidth	70 MHz to 200 MHz
Channels	2 or 4
Vertical Sensitivity	1 mV/div to 10 V/div
Vertical Resolution	8-bit
Timebase Range	2 ns/div to 50 s/div
Memory Depth	14 Mpts
Input Impedance	1 MΩ ± 1%
Trigger Modes	Edge, Pulse, Video
Waveform Capture Rate	50, 000 wfm/s
Interfaces	USB, LAN
Power Supply	100-240 VAC
Display	8-inch WVGA (800x480) LCD