Rigol DS2000E Series Programming Guide

2 Command System RIGOL
DS2000E Programming Guide 2-1
2 Command System
This chapter introduces the command subsystems of DS2000E command set.
The topics of this chapter:
 :AUToscale
 :CLEar
 :RUN
 :STOP
 :SINGle
 :TFORce
 :TLHAlf
 IEEE 488.2 Common Commands
 :ACQuire Commands
 :BUS<n> Commands
 :CALCulate Commands
 :CALibrate Commands
 :CHANnel<n> Commands
 :CURSor Commands
 :DISPlay Commands
 :FUNCtion Commands
 :LAN Commands
 :MASK Commands
 :MEASure Commands
 :RECall Commands
 :REFerence Commands
 :SAVE Commands
 :SYSTem Commands
 :TIMebase Commands
 :TRIGger Commands
 :WAVeform Commands
Note:
1. Unless otherwise noted, the descriptions and parameter ranges in this manual are based on
DS2202E.
2. For parameter setting commands (such as time, frequency and amplitude), the oscilloscope can only
accept numbers and set the parameters using the default units; it cannot recognize the units sent
with the parameters. For the default unit of each parameter, please refer to the description in each
command in the following introductions.

Rigol DS2000E Series Specifications

General

Brand	Rigol
Model	DS2000E Series
Category	Test Equipment
Language	English