Rigol DS2000E Series Programming Guide

2 Command System RIGOL
DS2000E Programming Guide
2-83
:CURSor Commands
 :CURSor:MODE
 :CURSor:MANual
 :CURSor:TRACk
:CURSor:MODE
Syntax
:CURSor:MODE <mode>
:CURSor:MODE?
Description
Set or query the cursor measurement mode.
Parameter
Name Type Range Default
<mode> Discrete {OFF|MANual|TRACk|AUTO|XY} OFF
Explanation
 OFF: disable the cursor measurement.
 MANual: enable the manual measurement with cursor.
 TRACk: enable the track measurement with cursor.
 AUTO: enable the auto measurement with cursor.
 XY: enable the X-Y cursor measurement. This mode is only valid when the horizontal time base mode
is X-Y (please refer to the
:TIMebase:MODE command).
Return Format
The query returns OFF, MAN, TRAC, AUTO, or XY.

Rigol DS2000E Series Specifications

General

Bandwidth	70 MHz to 200 MHz
Channels	2 or 4
Vertical Sensitivity	1 mV/div to 10 V/div
Vertical Resolution	8-bit
Timebase Range	2 ns/div to 50 s/div
Memory Depth	14 Mpts
Input Impedance	1 MΩ ± 1%
Trigger Modes	Edge, Pulse, Video
Waveform Capture Rate	50, 000 wfm/s
Interfaces	USB, LAN
Power Supply	100-240 VAC
Display	8-inch WVGA (800x480) LCD