Rigol DS2000E Series Programming Guide

RIGOL 2 Command System
2-262 DS2000E Programming Guide
:TRIGger:EDGe:SLOPe
Syntax
:TRIGger:EDGe:SLOPe <slope>
:TRIGger:EDGe:SLOPe?
Description
Set or query the edge type of edge trigger.
Parameter
Name Type Range Default
<slope> Discrete {POSitive|NEGative|RFALl} POSitive
Explanation
 POSitive: trigger on the rising edge of the input signal when the voltage level meets the preset
trigger level.
 NEGative: trigger on the falling edge of the input signal when the voltage level meets the preset
trigger level.
 RFALl: trigger on the rising or falling edge of the input signal when the voltage level meets the preset
trigger level.
Return Format
The query returns POS, NEG, or RFAL.
:TRIGger:EDGe:SOURce
Syntax
:TRIGger:EDGe:SOURce <src>
:TRIGger:EDGe:SOURce?
Description
Set or query the trigger source of edge trigger.
Parameter
Name Type Range Default
<src> Discrete {CHANnel1|CHANnel2|EXT|ACLine} CHANnel1
Return Format
The query returns CHAN1, CHAN2, EXT, or ACL.

Rigol DS2000E Series Specifications

General

Bandwidth	70 MHz to 200 MHz
Channels	2 or 4
Vertical Sensitivity	1 mV/div to 10 V/div
Vertical Resolution	8-bit
Timebase Range	2 ns/div to 50 s/div
Memory Depth	14 Mpts
Input Impedance	1 MΩ ± 1%
Trigger Modes	Edge, Pulse, Video
Waveform Capture Rate	50, 000 wfm/s
Interfaces	USB, LAN
Power Supply	100-240 VAC
Display	8-inch WVGA (800x480) LCD