9
Inspection and maintenance
Inspection and maintenance work
Operating Instructions – MOVIMOT
®
flexible
265
9.3 Inspection and maintenance work
9.3.1 Preliminary work regarding inspection and maintenance
Observe the following notes before you start with inspection/maintenance work:
WARNING
Risk of injury if the device starts up unintentionally, and danger of electrical voltage.
Dangerous voltages may still be present for up to 5minutes after disconnection from
the line voltage.
• Disconnect the device from the power supply with suitable external measures be-
fore you start working on the device and secure it against unintentional reconnec-
tion to the voltage supply.
• Secure the output shaft against rotation.
• Before removing the electronics cover, wait for at least the following time:
5minutes.
WARNING
Risk of burns due to hot surfaces.
Serious injuries.
• Let the devices cool down before touching them.
9.3.2 Connection cables
Observe the notes in chapter "Preliminary work for inspection and maintenance".
Check the connection cables for damage at regular intervals and replace if necessary.
9.3.3 Replacing the gasket between connection box and electronics cover
Spare part kit
The gasket is available as a spare part (1, 10 or 50pieces) from SEW‑EURODRIVE.
Content Part number
1 piece 18187765
10 piece 28266161
50 piece 28266188
29129451/EN – 12/2019
To Next Page
Loading...
Need help?
General
