4
Mechanical installation
Installing the device
Operating Instructions – MOVIMOT
®
flexible
31
4.5 Installing the device
4.5.1 Notes
• Only install the device on a level, low-vibration, and torsionally rigid support struc-
ture.
• Check the validity of the degree of protection using the information in the operating
instructions and the data on the nameplate.
• Ensure that cooling air supply is unobstructed and that air discharged by other
units does not influence cooling.
• Use suitable cable glands for the supply leads (use reducing adapters if neces-
sary).
• Seal the cable entries properly.
• Clean the sealing surfaces of the cover before reinstalling it.
4.5.2 Electronics cover
WARNING
Risk of burns due to hot surfaces.
Serious injuries.
• Let the devices cool down before touching them.
NOTICE
Loss of the guaranteed degree of protection.
Possible damage to property.
• When the cover is removed from the connection box, you have to protect the
cover and the wiring space from humidity, dust or foreign particles.
• Make sure that the cover is mounted properly.
29129451/EN – 12/2019
To Next Page
Loading...
Need help?
General
