5-12
SCANNERâ–ºSCANNER SEQUENCE
SELECTING THE RESOLUTION
The scanning resolution can be selected. After selecting scan mode and placing the original (steps 1 to 3 on page 5-5),
perform the procedure below.
The factory default setting for the resolution is "200dpi".
If you need to change the resolution, follow these steps.
1
Select "Resolution" with the [ ] or [ ] key, and then select the resolution.
2
Press the [OK] key.
Resolution
• The default resolution setting is 200 dpi. For typical text documents, a resolution of 200 dpi or 300 dpi produces
sufficiently legible image data. (A resolution of 200 dpi corresponds to the generally used "Fine" in fax mode. For this
reason, the 600 dpi setting should only be used in cases where high-clarity image reproduction is required, such as an
original that includes photographs or illustrations.
• The default setting can be changed in the system settings. ►page 7-23
To Next Page
Loading...
Need help?
General
