Siemens SED2 Commissioning Guide

4 / 100
Siemens Commissioning Guide CM1G5192en
Building Technologies Contents 29.07.2010
5.4 Control terminals............................................................................................28
5.5 Interconnecting SED2 via RS-485 .................................................................29
5.5.1 RS-485 bus termination .................................................................................29
6 Commissioning ............................................................................................30
6.1 DIP switch settings.........................................................................................31
6.1.1 Setting the DIP switches on the I/O board .....................................................31
6.1.2 DIP switch settings on the control board........................................................31
6.1.3 DIP switch settings on the AOP .....................................................................31
6.2 Checkliste für die Inbetriebnahme .................................................................32
6.3 Buttons and their functions on the operator panel (BOP and AOP)..............34
6.4 Setting parameters with the BOP or AOP......................................................35
6.5 Quick commissioning .....................................................................................36
6.6 Motor identification.........................................................................................37
6.6.1 Introduction ....................................................................................................37
6.6.2 Parameter settings.........................................................................................37
6.7 Flying start .....................................................................................................37
6.7.1 Flying start with systems having great mass moments of inertia...................37
6.8 Additional parameters ....................................................................................38
6.9 Copying SED2 parameters ............................................................................39
6.9.1 Procedure ......................................................................................................39
6.10 Automatic restart............................................................................................40
6.11 Resetting to factory defaults ..........................................................................42
7 Applications .................................................................................................43
7.1 Application 1 ..................................................................................................43
7.1.1 Parameter changes........................................................................................43
7.1.2 Recommended ramp times as a function of SED2 output .............................44
7.2 Application 2 ..................................................................................................44
7.2.1 Parameter changes........................................................................................45
7.3 Application 3 ..................................................................................................45
7.3.1 Parameter changes........................................................................................46
7.4 Application 4 ..................................................................................................46
7.4.1 Parameter changes........................................................................................47
7.5 Application 5 ..................................................................................................48
7.5.1 Parameter changes........................................................................................48
7.6 Application 6 ..................................................................................................49
7.6.1 Parameter changes........................................................................................50
7.7 Application 7 ..................................................................................................51
7.7.1 Parameter changes........................................................................................51
7.8 Application 8 ..................................................................................................52
7.8.1 Parameter changes........................................................................................53

Siemens SED2 Specifications

General

Brand	Siemens
Model	SED2
Category	DC Drives
Language	English