2-7. SY-467 Board/AT-195 Board
Preparation
1. Remove the top cover. (Refer to “2-2. Top Cover”.)
2. Remove the optical cable. (Refer to step 1 in “2-4-1. LEMO Connector Assembly”.)
3. Remove the top chassis. (Refer to step 1 in “2-5. Top Chassis/Air Distributor Assembly”.)
Procedure
1. Disconnect the fine-wire coaxial cable from the connector (CN600) on the SY-467 board.
2. Remove the two screws, and then remove the SY-467 board in the direction of the arrow.
3. Remove the two screws, and then remove the AT-195 board.
Front side
PSW
3 x 8
PSW
3 x 8
Fine-wire coaxial cable
SY-467 board
AT-195 board
(a)
(b)
(b)
(a)
CN600
B to B connectors
B to B
connectors
B to B connectors
HDCU3500/HDCU5500
2-16
To Next Page
Loading...
Need help?
General
