2-15-7. CN-4057 Board
Procedure
1. Remove the two screws (PSW3 x 8), and then remove the CN-4057 board subassembly.
2. Disconnect the flexible flat cable from the connector (CN001) on the CN-4057 board.
3. Remove the two hexagon screws, and then remove the CN-4057 board.
PSW
3 x 8
Locking compound 1401B
(1/2 size of a grain of rice)
Locking compound
application area
CN-4057 board subassembly
Hexagonal screws
D-sub panel
CN-4057 board
Flexible flat cable
CN001
Note
When attaching the hexagon screws, apply locking compound as shown in the figure.
4. Install the removed parts by reversing the steps of removal.
HDCU3500/HDCU5500
2-43
To Next Page
Loading...
Need help?
General
