Section 3
Software Update
3-1. Upgrading Software Programs
Software programs stored in the ROM (IC401) on the AT-195 board is upgraded by using a USB drive. The software
programs include application, operating system (OS), update software programs, and NMI LSI firmwares which is
independently upgraded.
Use the following procedures to upgrade the software programs.
Tip
The USB connector for connection to a USB drive is located to the right of the CALL button on the front panel. Detach
the USB connector lid to connect the USB drive.
3-1-1. Upgrading Application
Equipment Required
• USB drive (commercially available)
Tip
For recommended USB drive, contact your local Sony Sales Office/Service Center.
Preparation
Copy the camera application update data to the USB drive using the following procedure.
Note
For how to obtain the data file for update (hdcu5000_app.pkg), contact your local Sony Sales Office/Service Center.
1. Create the following directory in the USB drive.
\MSSONY\PRO\CAMERA\HDCU5000
2. Copy the data file for update “hdcu5000_app.pkg” to the directory created.
Procedure
1. Connect the USB drive that contains the program for update to the USB connector of this unit.
2. Turn on the power of the unit.
3. Open the [01<SOFTWARE PACKAGE>] page of the SERVICE menu. (Refer to “4-2-2. Description of SERVICE
Menu”.)
4. Select “APPLICATION” and then press the control knob.
5. A message “UPDATE OK?” appears. Select “YES.”
The unit restarts automatically and the version update starts.
Upon completion of the version update, a message “UPDATE SUCCEEDED” appears.
6. Turn off and on the power of the unit and confirm that the version has been updated on the VERSION1 page of
the DIAGNOSIS menu.
HDCU3500/HDCU5500
3-1
To Next Page
Loading...
Need help?
General
