Chapter
9
173
Clip Transitions
Overview
You can play frame memory video content linked to a
background transition, such as a mix or wipe.
A key for a clip transition is mixed with the background
du
ring execution of the transition.
Clip transition restrictions
• Pattern limits cannot be used.
• Transition preview cannot be used.
• It is not possible to set the transition rate of a clip
tra
nsition.
• A clip transition cannot be saved in an effect timeline as
a k
eyframe.
• The state of a clip transition during execution cannot be
sav
ed in a snapshot.
• When recalling a snapshot that includes a clip transition
wh
ile executing another clip transition, the subsequent
transition does not operate properly. Recall the
snapshot after the transition completes.
• When recalling a DME wipe snapshot while executing
a
clip transition, the image may be distorted.
• Transitions executed in two strokes, such as a preset
co
lor mix when the stroke mode is set to normal mode,
or a DME wipe with a picture-in-picture pattern, will
not execute properly.
• When a clip transition is selected, the wipe direction
sel
ection button in the transition control block/
transition control block (simple type) that is lit indicates
the playback direction of the frame memory clip.
The number of channels that can be used in a clip
tra
nsition will vary depending on the system signal
format.
Setting a Clip Transition
This section describes clip transitions using frame
memory output channels 1 and 2 on M/E-1 as an example.
Selecting a Transition Type
You can select a clip transition on a frame memory output
channel to use using the transition control block,
transition control block (simple type), or the menu.
To select using the transition control block
Press a [FM1&FM2 CLIP] to [FM15&FM16 CLIP]
b
utton, turning it on, in the transition control block/
transition control block (simple type).
For frame memory output channels 1 and 2, press the
[F
M1&FM2 CLIP] button, turning it on.
For details, see “Setting a transition type (transition
control block)” (page 99).
When the system signal format is 2160P, only the
[F
M1&FM2 CLIP] button, [FM3&FM4 CLIP] button,
and [FM5&FM6 CLIP] button, or the [FM7&FM8 CLIP]
button, [FM9&FM10 CLIP] button, and [FM11&FM12
CLIP] button can be selected depending on the setting in
the Home > Setup > Switcher > Box Settings > DME/FM
Channel Assign menu (19103.53).
To select using the menu
In the Home > M/E-1 > Bus/Transition > Transition >
Tr
ansition Type menu (11109.21), set a [FM 1&2 Clip] to
[FM 15&16 Clip] button in the [Transition Type] group
to the on state.
For frame memory output channels 1 and 2, set the [FM
1
&2 Clip] button to the on state.
For details, see “Setting the key transition type (menu)”
(page 99).
Note
Note
To Next Page
Loading...
Need help?
General
