470
Setting the reference signal format
You can set the reference signal format of a switcher
configured from multiple boxes in an island.
1
Open the MLS Manager Home > System > Island >
Format menu (60211.03).
2
In the [Reference Format] group, select the format of
the reference signal.
Tri Sync: S
elects HD tri-level sync.
BB:
Selects black burst or sync.
Setting the signal format of a cross-point
box
You can set the signal format of a cross-point box in an
island.
If the signal formats of a switcher and cross-point box do
no
t match, the cross-point box cannot be operated.
For details, see “Logical Switchers” (page 16) in
“System Configuration.”
1
Open the MLS Manager Home > System > Island >
Format menu (60211.03).
2
In the [XPT Box Signal Format] group, select a signal
format.
2160P 2SI:
Selects 2160P 2SI signal format.
1080P: Sel
ects 1080P signal format.
1080i: Se
lects 1080i signal format.
Configuring a Switcher
You can assign boxes and control panels to a switcher in
an island.
The box with a logical box ID of 1 becomes the primary
bo
x, and the other boxes become secondary boxes.
1
Open the MLS Manager Home > System > Island >
Logical Switcher Config menu (60211.04).
2
Select a tab to change the switcher to configure.
3
In the [Box] group list on the left, select an
assignment destination logical box ID.
4
In the [Box] group list on the right, select a box to
assign to the switcher.
5
Press the [Assign] button.
Changing a box from a primary box to a secondary
b
ox will delete the content data and package files
stored in the box.
To release a box assignment
Press the [Release] button to release the box
assi
gnment for the selected logical box ID.
When a box assignment is released, the license
assi
gned to the box is also released.
6
In the [Panel] group list on the left, select an
assignment destination control panel ID.
7
In the [Panel] group list on the right, select a control
panel to assign to the switcher.
8
Press the [Assign] button.
To release a control panel assignment
Press the [Release] button to release the control panel
assi
gnment for the selected control panel ID.
Configuring Box Network Settings
You can configure the network settings of each box in an
island.
Setting the network interface
You can configure the following six types of network
interface for each box.
• Standard interface 1 (STD 1):
LAN 1 connector
(
d (see page 62) on rear of box) settings
• Standard interface 2 (STD 2):
LAN 2 connector
(
e (see page 62) on rear of box) settings
• Expansion interface 1 (OPT 1):
Network expansion 1 connector
1)
(p (see page 62) on rear of box) settings
• Expansion interface 2 (OPT 2):
Network expansion 2 connector
1)
(o (see page 62) on rear of box) settings
• Expansion interface 3 (OPT 3):
Network expansion 3 connector
1)
(n (see page 62) on rear of box) settings
• Expansion interface 4 (OPT 4):
Network expansion 4 connector
1)
(m (see page 62) on rear of box) settings
1) Can be used when a network card is installed in the PCIe slot of the box.
Note
Note
Note
To Next Page
Loading...
Need help?
General
