62
d LAN 1 connector (RJ-45, 1000BASE-T compliant)
LAN connector for standard interface 1.
Used to control devices connected to the network of the
swit
cher system.
e L
AN 2 connector (RJ-45, 1000BASE-T compliant)
LAN connector for standard interface 2.
Used to connect with an external network.
f REF
connectors (BNC type)
Connect to a tri-level sync signal or black burst signal
when
using the unit synchronized to an external reference
signal.
The two connectors are loop-through connectors.
Wh
ichever is used as the input signal, the other can be
used as an output signal. When not using loop-through,
terminate the unused connector using a 75 ohm
terminator.
g REF
OUT connector (BNC type)
Outputs the internal reference signal when an external
r
eference signal is not being used.
h connector (USB 3.0, Type A)
Connect to a USB device such as a USB drive or
key
board.
i connector (USB 2.0, Type A)
Connect to a USB device such as a USB drive or
key
board.
j U (si
gnal ground) terminal
Connect to a ground wire.
k AC IN A, B, C, D con
nectors
Connect to an AC power supply using an AC power cord
(
sold separately).
l GP
I 1 and 2 connectors (D-sub 25-pin)
Can be used when an MKS-X1700 Legacy Interface
B
oard (option) is installed.
Used as a GPI input port and GPI output port.
Can also be used as a tally input/output port.
m N
etwork expansion 4 connector
n N
etwork expansion 3 connector
o N
etwork expansion 2 connector
p N
etwork expansion 1 connector
PCIe slot. Supports third-party network expansion cards.
Used as interface expansion 1 to 4 LAN connectors.
The connectors are numbered 1 to 4 or 4 to 1 depending
on
the product.
For details about recommended products, consult your
So
ny representative.
For details, see “Configuring Box Network Settings”
(page 470).
q RE
MOTE 1/2, 3/4, 5/6, 7/8 connectors (RJ-45,
RS-422 compliant)
Can be used when an MKS-X1700 Legacy Interface
B
oard (option) is installed.
Connect to a device that supports VTR (Sony 9-pin VTR
pr
otocol), disk recorder (Video Disk Communications
Protocol, Odetics protocol), or P-Bus (Peripheral Bus II
protocol) protocols.
Can also be used as a tally output port.
To Next Page
Loading...
Need help?
General
