471
The box LAN connectors and configurable LAN types
supported by each network interface are shown below.
a) Number corresponding to the description of parts on the rear of the box.
To set standard interface 1 (STD 1)
1
Open the MLS Manager Home > System > Island >
Box Network menu (60211.05).
2
In the [Network I/F] group list, select standard
interface 1 network interface of the target box to set.
Place a check mark for the target box network
i
nterface to set (multiple selection supported).
Multiple selection is supported only for LANs of the
s
ame type (Ctrl LAN).
3
Press the [Edit Network I/F] button.
The [Standard Network I/F 1 Settings] window
ap
pears.
The standard interface 1 addresses can only be set
man
ually.
4
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
When multiple network interfaces are selected,
co
nsecutively numbered IP addresses are set.
5
Press the [Prefix Length] button for [IPv4] and enter
a prefix length in the numeric keypad window.
When multiple network interfaces are selected, the
sa
me prefix length is set for all selected network
interfaces.
6
Press [OK].
To set an interface other than standard interface
1 (
STD 1)
1
Open the MLS Manager Home > System > Island >
Box Network menu (60211.05).
2
In the [Network I/F] group list, select a network
interface other than standard interface 1 of the target
box to set.
Place a check mark for the target box network
in
terface to set (multiple selection supported).
Multiple selection is supported only for LANs of the
same t
ype (such as Util LAN 1 type, User LAN 1
type).
3
Press the [Edit Network I/F] button.
A setup window for the selected network interface
app
ears.
4
Press the [LAN] button and select a LAN to set from
the pull-down list.
The types of LAN which can be set will vary
dep
ending on the selected network interface.
When multiple network interfaces are selected, the
[
LAN] button is grayed out and cannot be changed.
When a LAN for redundancy is selected
The same settings as the main LAN are applied.
Proc
eed to step 11.
5
Press the [Mode] button for [IPv4] and select a setup
mode from the pull-down list.
Off:
Do not use IPv4.
Manual: S
et manually.
DHCP: S
et automatically using DHCP.
When [Off] or [DHCP] is selected, proceed to step 8.
Network I/F Configurable LAN Connector
a)
STD 1 • Control LAN (Ctrl LAN) f
STD 2 • Utility LAN 1 (Util LAN 1)
• No setting (Off)
g
OPT 1 • For control LAN
re
dundancy (Ctrl LAN
Redundant)
• No setting (Off)
p
OPT 2 • Utility LAN 2 (Util LAN 2)
• For utility LAN 1
redundancy (Util LAN 1
Redundant)
• No setting (Off)
o
OPT 3 • User LAN 1 (User LAN 1)
• No setting (Off)
n
OPT 4 • User LAN 2 (User LAN 2)
• For user LAN 1
re
dundancy (User LAN 1
Redundant)
• No setting (Off)
m
Note
Note
Note
Note
Note
Note
To Next Page
Loading...
Need help?
General
