Edition
2018
Workshop Manual
PARK PRO 340 IX
Chapter
7 Electrical system
Page
90
7.7 Diagnostic Tool
B Cod. 1134-9185-01
A
The machine is tted with an 8-pole connector (A)
for connection to the Diagnostic Tool.
This device together with the programmer (B)
code 1134-9185-01, can perform the following
functions:
1. Software updates of the electronic cards;
2. Diagnostics section to perform display testing
and to check the keypad and control seat
switch;
3. Access to data recorded on the electronic
board (service hours, number of engine start-
ups, number of battery warnings, max. revs
reached by the engine, hours of use on slopes
exceeding 10°, etc.);
4. Transfer of data recorded on one electronic
card to another (useful when the electronic
card has to be replaced).
For further information see:
http:/ www.gggpartsandservice.com ==> Service ==> Software ==> STIGA - Diagnostic Tool
To Next Page
Loading...
Need help?
General
