Tektronix TDS6000 Series Service Manual

Troubleshooting
TDS7104 & TDS7054 Service Manual
6-- 75
3. Touch Continue.
Hard Disk Drive Maintenance
Use the same procedures to maintain the oscilloscope hard disk drive that you
use to maintain a hard disk drive in a personal computer.
Using ScanDisk, attempt to fix the disk without destroying data on the disk. To
use ScanDisk, perform the following steps:
1. Remove the hard disk drive from the oscilloscope.
2. Install the hard disk drive into personal computer.
3. Power up the computer and run ScanDisk. Set Scandisk to perform a
thorough surface scan and to automatically fix errors.
H Using Microsoft Windows 98: select Start\Programs\Accessories\System
Tools\ScanDisk
H Using Microsoft MSDOS: enter SCANDISK drive: /SURFACE
/AUTOFIX
4. If ScanDisk will not repair the disk, format the hard disk drive using the File
Utilities Format command. Format will destroy all data currently on the disk.
5. If reformatting the hard disk and reloading the software will not repair the
disk, install a new hard disk drive.

Tektronix TDS6000 Series Specifications

General

Brand	Tektronix
Model	TDS6000 Series
Category	Test Equipment
Language	English