Rev. 000
TX 413 Service Manual
2-3
SPECIFICATIONS
Hydraulic System:
Electric System:
Item Specification
Gear Pump Single section 6.9 gpm (26.12 liter/min) gear pump powers the loader and auxiliary
hydraulic systems.
Loader Valve Two-spool mono-block valve controls loader functions via a single lever joystick. The
valve has a power beyond circuit which feeds the auxiliary circuit.
Main Relief Setting: 2650 psi (182.71 bar)
Work Port Reliefs: 2030 psi (140 bar) for the bucket curl and loader lower circuit.
Auxiliary Valve Single spool valve controls the auxiliary flow to the Dingo TX attachments. Flow is
received via power beyond circuit in loader valve. The valve is actuated by a two-step-
motion lever for forward and reverse flows. Relief is provided by loader valve at 2650 psi
(182.7 bar).
Hydrostatic Pump The traction circuit is powered by dual hydrostatic pumps in a closed loop system. The
pumps have a service bypass valves for towing and have shock valves to limit circuit
pressure spikes. The Hydro-Gear BDP-10A pumps are mechanically actuated by the
patented Dingo TX traction control system.
Pump Displacement: .61 in
3
/rev (10cm
3
/rev)
Pump Speed: 3600 rpm
Shock Valve Relief: 2320 psi (160 bar)
Wheel Motors Two Parker-Ross TF hydraulic motors directly drive the track wheels.
Displacement: 24.7 in
3
/rev (40.4cm
3
/rev)
Mounting: 4-bolt through frame
Lift Cylinders The lift circuit has a single hydraulic cylinder that control loader height.
Working Pressure: 2650 psi (182.7 bar)
Dump Cylinders The Quick-Attach angle is controlled by a single hydraulic cylinder.
Working Pressure: 2650 psi (182.7 bar)
Tank The hydraulic tank is a fabricated weldment integrated into the main frame. The tank
has a cleanout access, stainless screen at the fill port, and a remote breather connected
via hose.
Capacity: 10 gallon (37.8 liter)
Filter 10 micron spin-on filter in gear return circuit
Item Specification
Battery 12 volt, BCI group 55 battery with 585 CCA
Hour Meter Frame mounted with Service Interval icon.
Fuel Shut Off 12 VDC ignition coil type
Ignition Ignition switch is panel mounted with STOP-RUN-START positions.
Fuses The machine has a fuse block with 3 separate fuses, 10 amp, 25 amp,
and 30 amp circuits.
To Next Page
Loading...
Need help?
General
