Toro Dingo TX 413 User Manual

Rev. 000
TX 413 Service Manual
3-7
MAINTENANCE
10. Replace the hydraulic oil filter.
11. Start the engine, remove the cylinder lock, raise
and lower the loader arm, then drive the unit for-
ward and backward to purge air from the system
and check for leaks.
12. Stop the engine.
13. Check the hydraulic fluid level and top it off if
necessary.
Vents - Fuel Tank and Hydraulic Tank
There are two vents located on the top of the unit.
The top one is the fuel tank vent, A, and the bottom
vent is for the hydraulic reservoir tank, B, (Fig. 016).
Figure 016 DSC-0773
After every 100 operating hours, check the hydraulic
lines and hoses for leaks, loose fittings, kinked lines,
loose mounting supports, wear, weather, and chemi-
cal deterioration. Replace all moving hydraulic hoses
every 1500 hours or 2 years, whichever comes first.
Make necessary repairs before operating.
Checking the Hydraulic Lines
Note: The only maintenance to perform on these
is to make sure they are clean and free of
any debris.
Fuse Block
The fuse block is located inside the rear cover. There
are three fuses in the electrical system. One location
for the fuse is blank, for optional head lights (Fig.
017).
Figure 017 DSC-0753A
Servicing the Engine, Air Cleaner
Replacement, and Spark Plug Servicing
See the Dingo TX 413 Operator's Manual. Or, for
more details, see the Honda Engine Operator’s or
Service Manuals.
Fuses can be removed to check continuity. The test
meter should read less than 1 ohm.
A. 30 amp - Main/Starter, Blade Type
B. 25 amp - Charging, Blade Type
C. Blank - Optional Headlights, 10 amp
D. 10 amp - Ignition Circuit, Blade Type
A
B
A
A
B
B
C
C
D
D

Toro Dingo TX 413 Specifications

General

Brand	Toro
Model	Dingo TX 413
Category	Compact Loader
Language	English