Toro Dingo TX 413 User Manual

Rev. 000
Recommended Maintenance Schedule
MAINTENANCE
3-8
TX 413 Service Manual
Maintenance Service Interval
 Maintenance Procedure
8 hrs
 Grease the traction unit
 Check engine oil level
 Check for loose fasteners
 Inspect the tracks for damage or wear
 Change hydraulic filter after the initial 8-10
operating hours
25 hrs
 Check hydraulic oil
 Inspect hydraulic lines for leaks
50 hrs
 Clean the foam pre-filter with liquid soap and warm
water
 Clean the paper air filter by lightly tapping on flat
surface
100 hrs
 Change engine oil
 Replace paper air filter
 Check battery electrolyte level
 Adjust track tension
 Check battery cable connections
 Check the spark plug
200 hrs
 Check hydraulic filter
300 hrs
 Replace the spark plug
400 hrs
 Inspect fuel lines for leaks
 Change hydraulic oil and filter
Yearly Storage
 Check for loose fasteners
 Touch up chipped paint
 Adjust track tension
 Check tracks and road wheels
 Complete all yearly maintenance procedures
specified in the engine operator’s manual
 Charge the battery and disconnect the cables
(storage only)
 Drain the gasoline (storage only)

Toro Dingo TX 413 Specifications

General

Brand	Toro
Model	Dingo TX 413
Category	Compact Loader
Language	English