Triumph Scrambler 900 User Manual

MAINTENANCE AND ADJUSTMENT
123
Steering/Wheel Bearings
Caution
To prevent risk of injury from
the motorcycle falling during the
inspection, make sure that the
motorcycle is stabilized and secured
on a suitable support.
Do not exert extreme force against
each wheel or rock each wheel
vigorously as this may cause the
motorcycle to become unstable
and cause injury by falling from its
support.
Make sure that the position of the
support block will not cause damage to
the motorcycle.
Steering Inspection
Warning
Riding the motorcycle with incorrectly
adjusted or defective steering head
bearings is dangerous and may cause
loss of motorcycle control and an
accident.
The steering head bearings must be
lubricated and inspected in accordance
with scheduled maintenance
requirements. Always inspect the
wheel bearings at the same time as the
steering bearings.
Inspecting the Steering for Free Play
To inspect the steering:
▼ Position the motorcycle on level
ground, in an upright position.
▼ Raise the front wheel above the
ground and support the motorcycle.
▼ Standing at the front of the
motorcycle, hold the lower end of
the front forks and try to move
them forward and backward.
▼ If any free play can be detected in
the steering head bearings, ask
your authorized Triumph dealer to
inspect and rectify any faults before
riding.
▼ Remove the support and place the
motorcycle on the side stand.

Triumph Scrambler 900 Specifications

General

Displacement	900 cc
Max Torque	80 Nm @ 3, 250 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel, with twin cradles
Seat Height	790 mm
Bore x Stroke	84.6 mm x 80 mm
Clutch	Wet, multi-plate assist clutch
Swingarm	Twin-sided, tubular steel
Front Tyre	100/90-19
Rear Tyre	150/70 R17
Rake	25.8°
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	65 PS / 64 bhp (47.8 kW) @ 7, 250 rpm
Exhaust	Stainless steel 2-into-2 exhaust system with twin silencers
Front Suspension	41 mm telescopic forks, 120 mm travel
Rear Suspension	Twin shocks, adjustable preload
Front Brakes	Single 310 mm disc, Brembo 4-piston caliper, ABS
Rear Brakes	Single 255mm disc, Nissin 2-piston caliper, ABS
Front Wheel	19 x 2.5 in
Rear Wheel	17 x 4.25 in
Fuel Tank Capacity	12 L
Instrument Display	LCD multi-functional instrument pack with analogue speedometer
Length	2, 125 mm