GENERAL INFORMATION
59
SCROLL Button
The SCROLL button is used to
operate the following functions of the
instruments:
▼ Odometer functions (see page 43)
▼ Trip reset (see page 43)
▼ Clock reset (see page 44)
▼ Traction control functions (see
page 50).
Daytime Running Lights (DRL)
Switch (if equipped)
Note
Daytime running lights are manually
operated. They are not automatic.
The daytime running lights or dip
beam can be selected with the Daytime
Running Lights (DRL) switch.
To select daytime running lights, push
the DRL switch forward.
To select dip beam, push the DRL switch
rearwards.
When the daytime running lights are
turned on, the daytime running lights
indicator light will illuminate in the
instrument panel.
Turn Signal Switch
When the turn signal switch is pushed
to the left or right, the corresponding
turn signals will flash on and off.
The indicators can be canceled
manually. To manually turn off the
indicators, press and release the
indicator switch in the central position.
Horn Button
When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.
Cruise Control Button (if equipped)
When the cruise control button is
pressed, the cruise control is on. Cruise
control remains on until the button
is pressed again to turn off the cruise
control. Cruise control can be switched
on or off at any time but it cannot be
activated until certain conditions have
been met. For more information, see
page 49.
MODE Button
The MODE button allows throttle
response adjustment. Press and release
the MODE button to select one of the
different rider modes available (see
page 45 for more information).
High Beam Light
When the high beam button is
pressed the high beam will be
switched on. Each press of
the button will swap between
dip and high beam.
If daytime running lights are installed on
the motorcycle, the high beam button
has additional functionality.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
A lighting on/off switch is not installed
on this model. The tail light and license
plate light all function automatically
when the ignition is on.
The headlight will function when the
ignition is on. The headlight will go off
while pressing the starter button until
the engine starts.
To Next Page
Loading...
Need help?
General
