Triumph Scrambler 900 - Turn Signal Lights

MAINTENANCE AND ADJUSTMENT
146
Turn Signal Lights
The motorcycle is equipped with either
LED or bulb turn signal lights.
LED Turn Signal Lights
The LED turn signal light units are
sealed, maintenance free LED units.
The turn signal light assembly must be
replaced in the event of the failure of
the turn signal.
Scrambler 900 and Speed Twin 900 Turn
Signal Bulb Replacement
1
3
2
1. Lens
2. Bulb
3. Turn signal lens screw
The lens on each turn signal light is held
in place by an turn signal lens screw
located in the body of the light unit.
To replace the turn signal light bulb:
▼ Loosen the turn signal lens screw
and remove the lens to gain access
to the bulb for replacement.
▼ Carefully remove the bulb and
replace it with a new bulb.
▼ Installation is the reverse of the
removal procedure.
Bonneville T100, Bonneville T120
and Thruxton RS Turn Signal Bulb
Replacement
3
21
1. Bulb
2. Locating tangs
3. Lens
To replace the turn signal light bulb:
▼ Carefully twist the lens
counterclockwise and remove from
the turn signal to gain access to the
bulb.
▼ Gently press the bulb inwards and
twist counterclockwise. Replace with
a new bulb.
▼ Installation for the bulb is the
reverse of the removal procedure.
Caution
When installing the lens, make sure
that the locating tangs are correctly
aligned to the turn signal body.
▼ To install the turn signal lens,
align the locating tangs with
the turn signal body and twist
counterclockwise to secure.