General Information
30
Trip Meter
1. Trip information
2. Trip meter 1 display
3. Trip meter 2 display
Either trip meter shows the distance
that the motorcycle has travelled,
journey time, average fuel consumption
and average speed, all since the trip
meter on display was last reset to zero.
To access the trip meter information:
Turn the ignition to the ON position.
Press and release the SET button on the
left handlebar switch housing until the
desired trip meter is shown in the
display screen.
Press and release the SCROLL button on
the left handlebar switch housing until
the desired display is shown.
The trip meter display will scroll through
in the following order when pressing up
on the SCROLL button (it will scroll
through in the reverse order if pressing
down on the SCROLL button):
•Journey distance
•Average speed
• Average fuel consumption
•Journey time.
Each display provides the following
information:
Journey Distance
The total journey distance travelled
since the trip meter was last set to zero.
Average Speed
The average speed is calculated from
when the trip computer was last reset.
After being reset the display will show
dashes until one mile/km has been
covered.
Average Fuel Consumption
An indication of the average fuel
consumption. After being reset the
display will show dashes until 0.1 mile/km
has been covered.
Journey Time
The total time elapsed since the trip
meter was last set to zero.
To Next Page
Loading...
Need help?
General
