General Information
38
Traction Control Settings
The traction control can be set to one of
the following conditions:
Traction control defaults to ON after the
ignition has been switched OFF and then
switched ON again.
Traction Control Disable
To disable the traction control setting;
Make sure the motorcycle is stationary.
Turn the ignition switch to the ON
position, and put the engine start/stop
switch in the RUN position.
Press and release the SET button on the
left handlebar switch housing until
'SEtUP' is shown in the display screen.
Press and release the SCROLL button on
the left handlebar switch housing until
’ttc’ is shown in the display screen.
Press the SET button. ON or OFF is
shown flashing in the bottom section of
the display screen.
Press the SCROLL button to display OFF.
Press the SET button to select. There is
a one second delay until the setting is
shown.
Press the HOME button to return to the
trip 1 screen.
Traction Control Off Display
Do not attempt to adjust the traction
control settings while the motorcycle
is in motion as this may lead to loss of
motorcycle control and an accident.
On Optimal traction control setting
for road use, allows minimal
rear wheel slip.
Off Traction control is turned off.
The TC disabled warning light is
illuminated (see page 26).
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.
To Next Page
Loading...
Need help?
General
