General Information
37
Set Up Menu
To access the set up menu:
Make sure the motorcycle is stationary.
Turn the ignition switch to the ON
position.
Press and release the SET button on the
left handlebar switch housing until
'SEtUP' is shown in the display screen.
Press and release the SCROLL button
until the desired display is shown.
The display scrolls through in the
following order when pressing down on
the SCROLL button (it scrolls through in
the reverse order if up is pressed on the
SCROLL button):
• Triumph Traction Control (TTC)
• T-set (clock adjustment)
• Ind - self-cancelling indicators
• Service Interval Announcement (SIA)
• Units - change units (Imperial, US or
Metric).
Each display provides the following
information.
Triumph Traction Control (TTC)
Traction control helps to maintain
traction when accelerating on
wet/slippery road surfaces. If sensors
detect that the rear wheel is losing
traction (slipping), the traction control
system will engage and alter the engine
power until traction to the rear wheel
has been restored. The traction control
warning light will flash while it is
engaged and the rider may notice a
change to the sound of the engine.
Note:
• Traction control will not function if
there is a malfunction with the ABS
system. The warning lights for the
ABS, traction control and the MIL will
be illuminated.
Traction control is not a substitute for
riding appropriately for the prevailing
road and weather conditions. The
traction control cannot prevent loss of
traction due to:
• excessive speed when entering
turns,
• accelerating at a sharp lean angle,
•braking.
Traction control can not prevent the
front wheel from slipping.
Failure to observe any of the above
may result in loss of motorcycle
control and an accident.
To Next Page
Loading...
Need help?
General
