General Information
65
Universal Serial Bus (USB)
Socket
1. USB socket
A USB socket is located under the seat.
The connector provides a 5 Volt, 2 amp
power supply which is suitable for
charging electronic devices such as
mobile phones, cameras and GPS
devices.
The device must:
• have a compatible USB socket or
USB cable,
• be stowable in the space available
under the seat, and
• be able to withstand the vibrations
arising from normal motorcycle
usage.
To charge a device:
Make sure the ignition is switched off.
Remove the seat (see page 62).
Remove the cover from the USB socket.
Connect the device using a suitable USB
cable.
Fit the seat, making sure that the device
or USB cable are not trapped.
Turn the ignition ON and start the
engine.
When the device has finished charging,
switch off the ignition and remove the
seat.
Disconnect the device and USB cable
and refit the USB socket cover.
Refit the seat (see page 62).
The USB socket is not waterproof
unless the waterproof cap is installed.
Do not connect electronic devices
whilst it is raining.
Water in the USB socket could lead to
an electrical problem, resulting in
motorcycle damage, loss of motorcycle
control and an accident.
Make sure that all electronic devices
and cables are safely secured under
the seat when riding.
Make sure there is sufficient space
surrounding any electronic devices for
the seat to close without causing any
damage to the electronic device or the
motorcycle.