General Information
59
Resuming the Cruise Control Set
Speed
Cruise control is deactivated if one of
the following actions has been taken:
• Roll the throttle twist grip fully
forward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase speed by using the throttle
grip for more than 60 seconds.
The cruise control set speed is resumed
by pressing and releasing the RES/+ end
of the adjust button provided a set
speed has been stored.
The motorcycle must be travelling at a
speed between 19 to 100 mph (30 to
160 km/h) and be in 3
rd
gear or higher.
A stored set speed is indicated
by the word SET, below the
cruise control symbol in the
display screen. The stored set
speed remains in the cruise control
memory until the ignition switch has
been turned to the OFF position.
Note:
• The cruise control set speed display
will flash until the resumed set speed
has been achieved.
Fuel Requirement/Refuelling
Fuel Grade
Your Triumph engine is designed to use
unleaded fuel and will give optimum
performance if the correct grade of fuel
is used. Always use unleaded fuel with
an octane rating of 91 RON or higher.
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result in
loss of motorcycle control and an
accident.
The exhaust system is fitted with a
catalytic converter to help reduce
exhaust emission levels.
The catalytic converter can be
permanently damaged if the
motorcycle is allowed to run out of
fuel or if the fuel level is allowed to get
very low.
Always make sure you have adequate
fuel for your journey.
To Next Page
Loading...
Need help?
General
