General Information
51
Right Handlebar Switches
1. Engine stop switch
2. Cruise control adjust button
3. Starter button
4. Hazard warning lights button
Engine Stop Switch
In addition to the ignition switch being
turned to the ON position, the engine
stop switch must be in the RUN position
for the motorcycle to operate. The
engine stop switch is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine stop switch to the STOP position.
1. Engine stop switch, STOP position
2. Engine stop switch, RUN position
Note:
• Although the engine stop switch
stops the engine, it does not turn off
all the electrical circuits and this
may cause difficulty in restarting
the engine due to a discharged
battery. Ordinarily, only the ignition
switch should be used to stop the
engine.
Cruise Control Adjust Button
The cruise control adjust button is a two
way switch with the top marked RES/+
and the bottom marked SET/- (see
page 58).
1. Cruise control adjust button, RES/+
2. Cruise control adjust button, SET/-