General Information
39
T-set - Clock Adjustment
To reset the clock:
Make sure the motorcycle is stationary.
Turn the ignition switch to the ON
position.
Press and release the SET button on the
left handlebar switch housing until
'SEtUP' is shown in the display screen.
Press and release the SCROLL button
until 't-SEt' is shown.
Press the SET button again and either
’24 Hr’ or ’12 Hr’ clock is shown.
Press the SCROLL button to select the
desired clock display and then press the
SET button. The hour display will start to
flash and the word 'Hour' is shown in the
display screen.
Note:
• The hour/minute display will
increase when pressing the SCROLL
button up or decrease when pressing
the SCROLL button down.
1. HOME button
2. Hours read-out
3. Minutes read-out
4. Hour selected for adjustment
To reset the hour display:
Make sure that the hour display is still
flashing and the word 'Hour' is shown.
Press the SCROLL button to change the
setting. Each individual button press will
change the setting by one digit. If the
button is held, the display will
continuously scroll through in single
digit increments.
When the correct hour display is shown,
press the SET button. The minutes
display will begin to flash and the word
'Min' is shown in the display screen. The
minutes display is adjusted in the same
way as for the hours.
Once both hours and minutes are
correctly set, press the SET button to
confirm and 't-SEt' is then shown in the
display screen.
Press the HOME button and the journey
distance in the trip 1 menu is shown in
the display screen.
To Next Page
Loading...
Need help?
General
