General Information
33
Riding Mode Selection
Riding modes may be selected when the
motorcycle is stationary or moving.
There is a one second time-out when
pressing the MODE button between each
of the modes to allow for further
scrolling to take place.
The selected mode is automatically
activated once the one second time-out
has elapsed, and the conditions for
switching modes have been met.
Note:
• The last selected riding mode is
remembered and activated when the
ignition is switched ON.
Selecting a Riding Mode – with the
Motorcycle Stationary
Note:
• If the ignition is switched on and the
engine not started, the instruments
will display the odometer for five
seconds.
To select a riding mode:
Press and release the MODE button on
the instrument housing until the desired
riding mode is flashing in the display.
1. Current (active) riding mode
2. Selected riding mode (flashing)
The selected riding mode is
automatically activated one second after
the MODE button is pressed, if the
following conditions are met:
With the Engine Off
• The ignition is switched ON.
• The engine stop switch is in the RUN
position.
With the Engine Running
• Neutral is selected or the clutch is
pulled in.
After selecting a riding mode, operate
the motorcycle in an area free from
traffic to gain familiarity with the new
settings.
Do not loan your motorcycle to
anyone as they may change the riding
mode settings from the one you are
familiar with, causing loss of
motorcycle control and an accident.
To Next Page
Loading...
Need help?
General
