General Information
63
Seat Care
To refit the seat:
Engage the slot on the front of the seat
to the bracket at the rear of the fuel
tank.
Press down at the rear of the seat to
engage in the seat lock.
Triumph Accessory D-lock
Storage
Space is provided under the seat to
store a Triumph accessory D-lock
(available from your Triumph dealer).
To se c u r e the loc k:
Remove the seat (see page 62).
Position the U-section of the lock to the
seat support features on the underside
of the seat. Make sure that the open end
faces towards the rear of the seat.
Position the lock body into the storage
tray and secure using the strap as
shown below.
1. Lock U-section
2. Support features
3. Lock body
4. Strap
Refit the seat.
To prevent damage to the seat or seat
cover, care must be taken not to drop
the seat.
Do not lean the seat against the
motorcycle or any surface which may
damage the seat or seat cover.
Instead, place the seat, with the seat
cover facing upwards, on a clean, flat
surface which is covered with a soft
cloth.
Do not place any item on the seat
which may cause damage or staining
to the seat cover.
To prevent detachment of the seat
during riding, after fitting always
grasp the seat and pull firmly
upwards.
If the seat is not correctly secured in
the lock, it will detach from the lock.
A loose or detached seat could cause
loss of motorcycle control and an
accident.
To Next Page
Loading...
Need help?
General
