BA 50Z3/6003 en – Edition 4.3 * 5003b330.fm 3-45
Operation
3.26 Seat belt
Driving or working with the seat belt unbuckled is forbidden
Risk of injury.
☞ Always buckle up before moving or working with the machine.
• Do not fasten a twisted seat belt.
• Seat belt must run over the hips – not over the stomach – and must
always be applied tightly.
• Do not place the seat belt over hard, edged or fragile items (tools, metre
rule, glasses, pen) carried inside your clothes.
• Never buckle up 2 persons with one seat belt.
• Check the condition of the seat belt regularly. Have damaged seat belt
elements immediately replaced by a workshop.
• Always keep the seat belt clean, as coarse dirt can impair proper functioning.
• Seat belt buckle must not be obstructed by foreign bodies (paper or sim-
ilar); otherwise the buckle latch cannot lock into place.
After an accident the belt strap is stretched and no longer serviceable, even if
no optical defects can be detected.
In a further accident, the seat belt
Will not provide adequate protection.
☞ Replace the seat belt after every accident.
☞ Have fastening points and seat fixture checked for bearing capacity.
Seat belt 14 is for the user’s safety during work on construction sites and during road
travel.
Fastening the seat belt:
☞ Fasten seat belt 14 as follows before moving the machine:
• Hold belt on buckle latch A and run it slowly and steadily over the hips to buckle B.
• Insert buckle latch A into buckle B with an audible click (pull test).
• Tighten the seat belt by pulling at its end.
➥The seat belt must always be tightly in place over the hips.
Unfastening the seat belt:
☞ Unfasten seat belt 14 as follows:
• Hold the seat belt.
• Press red switch C on buckle B.
➥Latch A is released from buckle B by spring pressure.
• Slowly return the seat belt to the retractor
Fig. 103: Fastening the seat belt
14
B
A
14
B
A
C
Fig. 104: Unfastening the seat belt
To Next Page
Loading...
Need help?
General
