BA 50Z3/6003 en – Edition 4.3 * 5003b330.fm 3-23
Operation
3.13 Starting at low temperatures
☞ Turn the ignition key to position 2 and hold it in this position for about 15 seconds.
➥ Engine is preheated.
☞ Turn the ignition key to position “3” and hold it in this position until the engine starts.
➥ If the engine does not start after 10 seconds:
☞ Interrupt the start procedure and try again after about 1 minute.
➥ If the engine still does not start after the second try:
☞ Contact an authorized workshop for troubleshooting.
☞ Release the ignition key.
In general, a battery delivers less energy in cold conditions. Therefore ensure that
the battery is always well charged.
3.14 When the engine has started
☞ Check whether all indicator lights have gone out
☞ Let the engine warm up.
At cold temperatures:
☞ Increase the engine speed slowly.
☞ Do not run the engine at full load until it has reached its operating temperature.
Engine warm-up
After the engine has started, allow it to warm up at slightly increased idling speed until it
reaches its operating temperature of 70 °C (160 °F) (coolant). Run the engine with no load
during the warm-up phase (fold left-hand control lever base up). During the warm-up
phase, check for unusual noise, exhaust colour, leaks, malfunctions or damage. In case of
malfunctions, damage or leaks, park and secure the machine, and find out the cause for
the damage and have it repaired.
To Next Page
Loading...
Need help?
General
