2-6 BA 50Z3/6003 en – Edition 4.3 * * 5003b210.fm
Safety instructions
• Avoid any operation that might be a risk to machine stability.
• Always drive straight ahead when driving uphill or downhill. Always keep the load on
the downhill side of the machine.
Do not exceed a maximum longitudinal inclination of 15°.
Do not exceed a maximum lateral inclination of 10°.
Always keep the attachments/work equipment close to the ground.
• On sloping terrain always adapt your drive speed to the prevailing ground conditions.
Never change the drive speed on, but before a slope.
• Before leaving the seat always secure the machine against unintentional movement
and unauthorized use.
Lower the attachments to the ground.
• Before starting work check whether
• all safety devices are properly installed and functional.
• Before moving the machine or before taking up work:
• Ensure that visibility is sufficient.
• Adjust your correct seat position, never adjust the seat when driving or working.
• Fasten your seat belt.
• Inspect the immediate area (children).
• In the work area the user is responsible for third parties.
• Caution when handling fuel – increased danger of fire.
• Ensure that fuel does not come into contact with hot parts.
• Do not smoke during refuelling, and avoid fire and sparks.
• Switch off the machine before refuelling.
• Do not smoke.
• Never get on or off a moving machine and never jump off the machine.
• Should the lights of the machine not be sufficient for performing work safely, provide
additional lighting of the work area.
• Installed work lights must not be switched on for travel on public roads. They can be
switched on in work operation if users of public roads are not dazzled.
• The drive pedals take time getting used to them. Therefore, adjust the drive speed to
your abilities and the circumstances.
2.8 Information on visibility
Before putting the machine into operation, perform a visual check to ensure that there are
neither persons nor objects or other sources of danger around the machine.
When using the machine, check the surroundings constantly in order to identify potential
hazards in time.
Before using the machine, before starting work or when changing users, ensure that all visual aids
(mirrors) work correctly, that they are clean and adjusted in accordance with the instructions in this
Operator’s Manual. The operator must observe the local regulations.
Do not make any changes or modifications that impair visibility. Otherwise the machine
does not meet the requirements for conformity and licensing.
To Next Page
Loading...
Need help?
General
