3-60 BA 50Z3/6003 en – Edition 4.3 * * 5003b330.fm
Operation
3.35 Exit through the door (up to serial no. AH02764)
When entering or exiting the cab –
Risk of accidents.
☞ Before exiting the cab, stop and secure the machine – see chapter 3.18
Parking the machine on page 3-29.
• Lower the boom.
• Stop the engine.
• Remove the ignition key.
• Move control levers 3 and 4 in all directions repeatedly.
☞ Raise control lever base 5 with handle A to position B.
➥ The gas strut keeps the control lever base in the top position.
Do not use handle A on the control lever base, the outside mirror (option) or its
bracket as a support to ease your entrance or exit from the cab:.
☞ Use the entrance handles on the cab.
☞ Fold control lever base 5 down to position C once you are in the cab.
➥ The gas strut keeps the control lever base in the lower position.
Do not adjust the height of the control lever base to ensure that the contacts
between the safety switch and the control lever base are not affected.
If work is performed on the control lever base, check the safety switch and stop
bolt D under all circumstances.
Fig. 136: Control lever base
A
3
5
4
5
A
C
B
D
To Next Page
Loading...
Need help?
General
