EasyManuals Logo
Home>WinGD>Marine Equipment>X62DF-S2.0

WinGD X62DF-S2.0 User Manual

Default Icon
259 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Marine Installation Manual 2022-03 4-26
4 Ancillary Systems
4.4 Lubricating oil systems
X62DF-S2.0
System oil
The pistons of the WinGD X62DF-S2.0 engine feature highly efficient jet-shaker
cooling. The system oil must have basic properties as follows:
• Additive-type oil
• A viscosity of SAE 30
• Minimum Base Number (BN)
1)
of 5.0 mg KOH/g
• Minimum failure load stage of 11± 1 related to the FZG gear oil test method
A/8.3/90 according to ISO 14635-1
2)
• Detergency properties
• Thermal stability
• Anti-corrosion properties
• Anti-foam properties
• Demulsifying performance
The consumption of system oil is given in Table 1-4,  1-6.
The validated system oils can be found in the document Lubricants, which is
provided on the WinGD webpage under the following link:
Lubricants
For additional information please contact the oil supplier.
4.4.3 Flushing the lubricating oil system
For flushing of the lubricating oil system refer to the latest version of the relevant
Instruction (DG 9722), which is provided on the WinGD webpage under the fol-
lowing link:
Instruction for flushing - Lubricating oil system
4.4.4 Lubrication for turbochargers
For lubricating oil for turbochargers equipped with separate lubricating oil sys-
tems the recommendations given by the supplier must be observed.
4.4.5 Cylinder lubricating oil system
Cylinder lubrication is carried out by a separate system, working with the
once-through principle. A hydraulically actuated dosage pump feeds cylinder lu-
bricating oil to the surface of the cylinder liner through quills in the liner. The oil
supply rate is adjustable and metered to suit the age and running condition of
piston rings and liners.
For cylinder lubricating oil consumption refer to Table 1-4,  1-6.
1) The Base Number (BN), measured in mg KOH/g (test method ASTM D2896), is a
measure of the alkalinity of the oil. The BN of the cylinder oil is not an index for de-
tergency or for other properties of the cylinder oil.
2) The FZG gear machines located at the FZG Institute, Munich/Germany are the refer-
ence test apparatuses and must be used in the event of any uncertainty about test re-
peatability and reproducibility.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WinGD X62DF-S2.0 and is the answer not in the manual?

WinGD X62DF-S2.0 Specifications

General IconGeneral
BrandWinGD
ModelX62DF-S2.0
CategoryMarine Equipment
LanguageEnglish